Hi all
I am currently replacing some of cisco gigabit switch with Dell s4048 switches. I have two PS6100 series equallogic with gigabit interface as I am replacing cisco switch even current equallogic have gigabit port I am planning to connect with Dell 10GB switch but when I connect equallogic to dell switch it did not work but the same network cable, if I move to cisco switch than it works fine. below are the detail of dell switches. My question here is do I need to do any special configuration to make dell equallogic and dell S4048 work together
> there are two switches and configured with stack. out of 8 equallogic ports from each controller two ports goes to one switches.
> Untaged VLAN is configured to each port
>Flowcontrol rx on tx off
>Spanning-tree rstp edge-port
>MTU: 9216
Looking forward to help.
Kind regards
Binaya